cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

How to show bend note in flat view of drawing.

kpaiva
1-Newbie

How to show bend note in flat view of drawing.

Hello. I am new to Creo and Ive been creating flat patterns using a family table. The bend notes do not show up even though they are turned on in options under sheet metal/bend notes display settings/show bend notes. The tangent bend lines show up however. How do I get the bend notes to show up? Thanks


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions
mbonka
15-Moonstone
(To:kpaiva)

Hello Kenneth Paiva

welcome to forum. See following picture and notes.

     1. set desired drawing model active

     2+3. show model annotations in desired drawing view

     4. show the model notes

     5. show bend axis

     6. GREEN color --- move your note als you wish (use mouse )

unbend_state-drawing_notes.jpg

---------------------------------------------------

Just a tip:

If you are looking for some functionality (icon) try following:

     1. right up COMMAND SEARCH

Creo-search_icon.jpg

Hope it can helps

Regards

Milan

View solution in original post

2 REPLIES 2
mbonka
15-Moonstone
(To:kpaiva)

Hello Kenneth Paiva

welcome to forum. See following picture and notes.

     1. set desired drawing model active

     2+3. show model annotations in desired drawing view

     4. show the model notes

     5. show bend axis

     6. GREEN color --- move your note als you wish (use mouse )

unbend_state-drawing_notes.jpg

---------------------------------------------------

Just a tip:

If you are looking for some functionality (icon) try following:

     1. right up COMMAND SEARCH

Creo-search_icon.jpg

Hope it can helps

Regards

Milan

kpaiva
1-Newbie
(To:mbonka)

I had been in that area but didnt know what to click. That worked. Thank you.

Announcements