Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
We are starting to implement weld in our sheetmetal parts and assemblies. Being new to this, need a little help......I am working in Creo2 and able to put the welds in, but they come in as quilts. How can I make these solid so the correct weight will be calculated? while I am at it......Is there a way to figure the total length of all the weld?
And how to show the weld symbols from those welds on the drawing? The annotation dialog window does have welds.
Any help would be appreciated.
Brad Lawrence