Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X
Hi!
Lately working on user specific requirements for thickness analysis. Especially on 3D thickness and Sectioning.
I want to know what would users prefer while calculating thickness of section.
There are typically two ways:
1) Try to fit a Sphere for 3D or have a section and try to fit a circle touching 3 points. Or try to fit largest dia
What would users prefer?
2) By Ray method draw a line from point perpendicular to face til it touches the other surface.
Want to know feedback from users designing plastic parts.
You can visit here for more information: www.geomcaliper.com
Awaiting your feedback!
Thanks,
Prashant