Is there a possibility to convert an assembly to a multibody part in CREO 10

[DILIP88]

Hi

I'm using Creo version 10.0.3.0

Is there any possibility in aforementioned version of Creo to make multi body part from the assembly.

thanks & Regards

Dilip

[VladimirN]

Some old article - "Is it possible to convert a Creo assembly into a multibody part in Creo Parametric 7+?":

https://www.ptc.com/en/support/article/CS339821 

https://community.ptc.com/t5/Creo-Parametric-Ideas/Provide-option-to-import-STEP-file-as-multi-body-part-instead-of/idi-p/664526 

[DILIP88]

Hi Vladmir

Thanks you for the reply.

Unfortunately i was not able to find the config.pro option intf3d_in_as_part.

[MartinHanak · Accepted solution]

---

@DILIP88 wrote:

Hi Vladmir

Thanks you for the reply.

Unfortunately i was not able to find the config.pro option intf3d_in_as_part.

---

Hi,

this option is hidden.

You have to open config.pro in Notepad, add intf3d_in_as_part yes at the end of file and save.

Restart Creo.