cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

The community will undergo maintenance on October 16th at 10:00 PM PDT and will be unavailable for up to one hour.

Is there a way to adjust the sensitivity of the 'section' dragger arrow?

seanmcdonn
11-Garnet

Is there a way to adjust the sensitivity of the 'section' dragger arrow?

When defining a section offset distance the dragger arrow is very helpful.  I often use it to quickly view a variety of sections through a part or assembly.

 

However, the dragger seems to jump in increments of about 0.032".  For smaller products this is far too large of an increment.  Is there any way to adjust the sensitivity of the dragger arrow?

 

 

 

ACCEPTED SOLUTION

Accepted Solutions


@seanmcdonn wrote:

When defining a section offset distance the dragger arrow is very helpful.  I often use it to quickly view a variety of sections through a part or assembly.

 

However, the dragger seems to jump in increments of about 0.032".  For smaller products this is far too large of an increment.  Is there any way to adjust the sensitivity of the dragger arrow?

 

 

 


Hi,

try setting *_GRID_INTERVAL config.pro option. Eg. INCH_GRID_INTERVAL

 


Martin Hanák

View solution in original post

2 REPLIES 2


@seanmcdonn wrote:

When defining a section offset distance the dragger arrow is very helpful.  I often use it to quickly view a variety of sections through a part or assembly.

 

However, the dragger seems to jump in increments of about 0.032".  For smaller products this is far too large of an increment.  Is there any way to adjust the sensitivity of the dragger arrow?

 

 

 


Hi,

try setting *_GRID_INTERVAL config.pro option. Eg. INCH_GRID_INTERVAL

 


Martin Hanák

Perfect!!  That works!!  Thank you very much

 

 

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags