Looking for info upgrading Intralink 9.1 build M060 to build M070

[SteveVarieur]

How difficult is it to upgrade from 9.1 build M060 to build M070? Any helpful documentation would be greatly appreciated.

Thanks Steve

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[davehaigh]

These are the only doc's I've seen.

Reference Documents


(9.1 M070) Creo Elements/View Clients Software Matrix<">http://www.ptc.com/view?im_dbkey=139525>

(9.1 M070) ProductView Standard 9.0 M130 Software Matrix<">http://www.ptc.com/view?im_dbkey=139772>

(9.1 M070) Windchill Customizer's Guide<">http://www.ptc.com/view?im_dbkey=138024>



David Haigh

[jzupfer]

Because 9.1 M070 is imminent (within the next week), but not yet available, the 9.1 M070 documentation is not yet posted to ptc.com.When it is accessible,I believe you can find much of what you need in the WindchillMaintenance Release Read This First document, which includes links to other MOR documentation, information about updated documentation, and any special instructions for installing and configuring the maintenance release.The 9.1 M060 Maintenance RTF provides a good example of this content.

I hope this is helpful.

Regards,

Jane

Jane Zupfer
VP, Windchill Publications
PTC