Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hello to everybody.
I've created a manikin in my assembly but when I click visual cones icon, this message comes out : "Cannot access visual cones (missing mode)"
Thanks
@Maurizio wrote: Hello to everybody. I've created a manikin in my assembly but when I click visual cones icon, this message comes out : "Cannot access visual cones (missing mode)" Thanks
Hi,
do you have full Manikin license ?
I noticed that I used a type of manikin in which there was not the possibility to use visual cones. Changing manikin is all ok.
