cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Manufacturing of Cables

unknown1
1-Newbie

Manufacturing of Cables

I have a suggestion for PTC, if they are monitoring. First off, being
able to route a cable and have all the pins correct and all that is great.
Being able to flatten that same cable out to dimension on a drawing is
also great. But lets finish the process off shall we. Let's have the
ability to take that flattened cable and "assemble" it. I worked a
contract at a Lockheed Martin manufacturing facility were all they did was
create assembly fixtures for cables. I'm sure there are alot of other
places that do the same. Job would have been alot easier if all I had to
do was to bring the flattend cable into an assemly that I could position
mating connectors, and any other assembly type hardware to a flat board
for the assemblers to place and route the wiring on. Maybe someone has
already suggested this but it has been on my chest for sometime and wanted
to get it out there. Anyway, thanks for listening to my babbling.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements