Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
Hello,
I am a student working on a project. And i am doing a simulation of a light pole connected to a house wall. So that the load of the light unit at the top is perpendicular to the bolts.
I have not modeled the bolts, but instead made a hole were the bolts are supposed to be. And made an contact surface (bolt head), were i constrained it (fixed ,x,y,z)
Can it be done like this?
Bertil
I will check.. Is there an guide or explanation available?