cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Missing Flange Wall bend Lines

dgschaefer
21-Topaz II

Missing Flange Wall bend Lines

WF4, M190

I've created a flange wall in my part that wraps around 3 straight walls and the bends in between (LH image).  I then cut out the deformed area (RH image).


[cid:image001.png@01CE09FA.BE412F20]  [cid:image002.png@01CE09FA.BE412F20]

In the flat, however, I get no bend lines for these walls.  I'm assuming that's because of how I built it.

Is there a way to get the bend lines, or do I need to remake these walls?

Thanks,

--
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
--
Doug Schaefer | Experienced Mechanical Design Engineer
LinkedIn
1 REPLY 1

IMHO you will need to rebuild the part. Attached is a screenshot from Creo Elements/Pro 5.0 (aka Wildfire 5 1/2.)

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags