What's the deal with using an offset in NC_Sheetmetal and it not recognizing that it will cut into the part on an acute angle? Am I missing something or is this just a limitation of the system? I have tried defining concave corner conditions with a fillet but it just seems to ignore it.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
