cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

No volume to Simulation part

nbroc01
1-Newbie

No volume to Simulation part

I am trying to run a structural analysis on a part which I converted to a
solid from an IGES file, but when I attempt to assign a material to the
part I get this error message... "The body does not contain any volume" I
was able to create a protrusion from the part after some repair work, but
there is part of the surface that remained after the protrusion was
created. Is this the problem or is there another issue?

-Nate
0 REPLIES 0
Announcements