Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
Hello Creo experts... I was hoping to reach out for some detailing help.
I have a part where several holes on different BC's need to be shown on an offset section view. If I do a offset section with only 2 lines, the view is fine but as soon as I 'jog' the section to go thru more holes, my offset section Full(Aligned) has geometry that is impossible to be erased. I have attached 2 images. 1 showing that if I have a relatively simple offset the section view is fine but as soon as I try to offset thru other features, the section view has extra geometry showing in the bore that I cant erase 😞
Solved! Go to Solution.
Try to change your sketch to something like attached. Sometimes this method works with the offset section.
For some reason, I have better luck when the x-section rotates the "other way".
Graphically like this:
Also check to make sure any cosmetics or sketches are hidden (or layers off) .
I've never seen this specific problem but i have seen some other unexpected things showing up.
Try to change your sketch to something like attached. Sometimes this method works with the offset section.
Thanks for taking time to reply...changed as you suggested but still have the lines in the bore that wont erase 😞
not having the view as projected and RESULT!
Thank you!!!!