If you add a drawing symbol to a parameter, PDMLink appears to mess it up either during check in or check out.
Anyone have a solution.
The top one is before, the bottom one is after. [cid:image002.png@01CB7B31.3204F230] David Haigh Phone: 925-424-3931 Fax: 925-423-7496 Lawrence Livermore National Lab 7000 East Ave, L-362 Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
The problem is related to our start parts. PTC was able to reproduce the issue, and have assigned a severity level of High to the SPR. They plan to fix it in a later release of WF4, 5,& 6. (Wildfire 6.0 is what the spr says, not creo)
Respond By Date
Windchill PDMLink is not recognizing text encoding when user using symbols characters in Pro/ENGINEER parameters value.