Paginating Hole Table

[Dale_Rosema]

I am working with Creo 4.0 M60

I am trying to paginate a hole table but am running into the issue of trying to "Set Extent". I get the error message "Could not set extent."

It looks like someone had the same issue 15 months ago with no solution:

https://community.ptc.com/t5/Detailing-MBD-MBE/Seperating-hole-table-on-to-multiple-sheets/m-p/560960

... and here Martin talks about "Set Extent" which I cannot do:

https://community.ptc.com/t5/Detailing-MBD-MBE/Repeat-Region-table-fitting-on-the-sheet/m-p/619460

The help file talks of "Set Extent" too:

https://support.ptc.com/help/creo/creo_pma/r6.0/usascii/index.html#page/detail%2Fhole_table_custom_create.html%23

https://support.ptc.com/help/creo/creo_pma/r6.0/usascii/index.html#page/detail%2FTo_Break_Report_Tables_on_the_Same_Sheet.html%23

Thanks, Dale

[TomU]

This article is for an older version, but might be worth trying:

https://www.ptc.com/en/support/article?n=CS37250

[Dale_Rosema]

It mentions that Paginate with repeat region table.

Is a "Hole Table" considered a repeat region table?

[Dale_Rosema · Accepted solution]

Caught a specific wording:

If I create the table with the number of rows I want, that works, but it doesn't see to allow me to change it after it was made (or I can't get back to the menu to set the number of rows).

Thanks,

Dale