Pattern slot hole

[chshasa1]

Hi All

i have a weird behavior within a pattern.

i created a sketch with points in each corner. 

on the top left, i created a slot hole with the direction as shown in picture. then i use the pattern command to pattern on the points of the sketch. 

the bottom right slot hole changes the direction. why does this happen?

  

[Dale_Rosema]

Are your points relative to the side of the slot.

It looks like the bottom right slot is rotated also.

[chshasa1]

Hi
no, the rest is ok (slot hole horizontal) only the right bottom one is rotated by 90°

[Dale_Rosema]

Are you patterning 1 point 8X or 2 points 4X?

[chshasa1]

i am pattering 1x slot hole and 2 normal holes (in the same sketch) 4 times using the points defined in the sketch created earlier.

[Dale_Rosema]

So is the question about the bottom right two holes or the slot or both?

[chshasa1]

both, slot hole and 2 holes are turned by 90°

[Dale_Rosema]

Are you patterning by direction, dimension or something else?

[chshasa1]

i patterned by point

[kdirth · Accepted solution]

Under the Options tab, unselect Follow curve direction.

[chshasa1]

thanks!