Hello All,
I am trying to create a plug weld that starts on a flat surface and extends out to a curved OD surface. The plug weld will not allow me to extend all the way to the curved surface. It will only allow the weld to go up to the outside/lowest part of the hole on the OD. Is there a way to make this happen? Id like to end up with something like what is shown in red below.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
