cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Predefining a sketch origin

StevenDumon
11-Garnet

Predefining a sketch origin

By what I experience in an assymetric sketch, inserting a sketch from a file or from a pallette initially places the white positioning handler in the center of the sketch, but only if there is an element such as a point or centerlines throuch that center. If no element is found in the center of the sketch, the handler seems to snaps to the element nearest to the center of the sketch.

 

A new sketch on the palette is a L-beam, which we preferrably position by its 'angle point', and where the center of the sketch is of no practical use.

 

A predefined position of the positioning handler on the sketch would provide a functionality similar to component interfaces, and would avoid repositioning the handler every time the sketch is used.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Top Tags