Pro/PIPING - How to recover insulation end points coordinates in a drawing ?

[jlecointre]

Reply Reply w/ Quote Edit Post

Hello all,

I cannot figure out how to recover end points coordinates of an insulation created in Pro/PIPIG (Pro/E WF2)in a drawing.

I only get an information window, but don't see any related parameter I could recover in a table, as it is possible for tubes.

Many thanks advanced.

Kind regards.

Jean-Michel.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.