Radius problem

[Jose_Costa]

Hello,

I´m trying to make a radius in the edge shown in first picture. The result I get is the second image. I want to achieve the third image only using a radius feature, how can I do it?

Jose

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[mpeterson · Accepted solution]

In the Sets tab try using the extend surfaces option. That should work.

[mganzer]

Mark Peterson is spot on.

[Jose_Costa]

That´s it. Thanks.

Jose