Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi,
Unable to create a repeat region bend table for the piping assembly. Refer attached snap for the repeat region syntax. Please support.
Solved! Go to Solution.
Review this posts, maybe they will help:
https://community.ptc.com/t5/3D-Part-Assembly-Design/Bending-table-with-Part-Co-ordinate-system/m-p/276045
https://community.ptc.com/t5/3D-Part-Assembly-Design/Pipe-Bend-Tables/m-p/381890
View solution in original post
I would like to combine Bend Table and Bend Location table into single table as per image.
But for some reason the machine bend values are not appearing in the combine table even though it has same repeat region index. pls support
