cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Repeat Regions for Wire Harness

mo185028
3-Visitor

Repeat Regions for Wire Harness

I created a repeat region for a wire harness, details include: From/To Connectors and Pins, Wire specs such as color gauge, length. All data are populated except for the From/To Pin names (harn.run.cond.from.pin.name). How do I resolve this? Thank you!

1 REPLY 1
oull
16-Pearl
(To:mo185028)

Hi,

Normally the entry port for wire must be linked to a pin then &harn.run.cond.from.pin.name will fil in the from/to pin name in the repeat region Table As described in Article - CS133154

 

https://www.ptc.com/en/support/article/CS133154

 

Please refer to Creo Help about how To Assign an Entry Port to a Pin Number :

 

http://support.ptc.com/help//creo/creo_pma/usascii/index.html#page/electrical_design/cable/About_Entry_Ports.html

http://support.ptc.com/help//creo/creo_pma/r8.0/usascii/index.html#page/electrical_design/cable/About_Entry_Ports.html

 

 

and to this video Demo at:

 

https://support.ptc.com/images/cs/articles/2018/09/1536220508kdQi/demo.mp4

 

Regards

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags