Good morning.
I seem to remember finding a procedure for replacing the Start Part that was used to create a model with a different Start part. I can't find it again, though, and I can't remember the procedure.
Do you have any idea where I could locate the post?
WF4, M220
Thanks,
John
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
