STL save - blue lines still on my model?
‎Aug 18, 2021
11:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Aug 18, 2021
11:56 AM
STL save - blue lines still on my model?
I am using Creo Parametric 6.0 6.0.5.1
I just saved an stl of a part. Now my part has blue lines all over it indicating the tessellation that was created during the stl save. How do I remove these lines and where in Creo Parametric does it indicate that these blue lines are visible? If someone else were to look at this model, how would they know why these lines are present, what they are, and how to remove them?
This is a question about the user interface. How is this change in model appearance being communicated to me by Creo Parametric? I see nothing new in the model tree.
Solved! Go to Solution.
Labels:
- Labels:
-
General
ACCEPTED SOLUTION
Accepted Solutions
‎Aug 18, 2021
12:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Aug 18, 2021
12:01 PM
2 REPLIES 2
‎Aug 18, 2021
12:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Aug 18, 2021
12:01 PM
Repaint the model.
There is always more to learn in Creo.
‎Aug 18, 2021
12:02 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Aug 18, 2021
12:02 PM
These are visuals of the STL export. Not sure why they are shown. You just need to repaint.