cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

SUMMARY: bending milled plate

jbrouch
3-Visitor

SUMMARY: bending milled plate

Thank you everyone for suggestions and ideas. I guess I was away from
SHEETMETAL for more years than I thought and not clear on what it could do.

My solution turned out to be rather simple:

Flat FIRST WALL; then SECTION SWEEP to cut my funny edge around the
perimeter; then simple EXTRUDE to cut some more material from center of one
surface (as long as I clicked "normal to surface"); then a BEND-ROLL to my
specified radius.





This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements