cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Searching for a hole feature

ptc-5471878
7-Bedrock

Searching for a hole feature

I got a yellow error while regenerating an assembly. It said Hole_105 lies outside the model or something to that effect. My problem is I don't know how to search for Hole 105.

And a side note, when I hit regenerate again that error doesn't come up again since my assembly has a green light. How should I make the assembly do a full regeneration so I can see the error again?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ACCEPTED SOLUTION

Accepted Solutions
Gucio
15-Moonstone
(To:ptc-5471878)

to find hole - you should do as at the image below. select your HOLE 105 and move to the right, close search window. having still hole selected RMB > Locate in model Tree (available only in part mode)

search.png

regards

gucio

Krzysztof

View solution in original post

2 REPLIES 2

Look in the message log or the trail file to better locate the problem.

Gucio
15-Moonstone
(To:ptc-5471878)

to find hole - you should do as at the image below. select your HOLE 105 and move to the right, close search window. having still hole selected RMB > Locate in model Tree (available only in part mode)

search.png

regards

gucio

Krzysztof
Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags