Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email.
X
I'm trying to create a Shrinkwrap of a medium size assembly, in WF3. It thinks for a very long time, then appears to go all the way through the process, even to the point of regenerating features in the new shrinkwrap part, upon which it fails. The message log is copied below. Any ideas what's going on here?
Merging component 94620 ... (5 left)
Processing merge results ...
Performing analysis... 100% done
Refining analysis... 2% done
Refining analysis... 100% done
162 of 570 components merged.
Regenerating N16-9122_SW0003 feature 6 out of 20 ...
.
Regenerating N16-9122_SW0003 feature 13 out of 20 ...
Feature regeneration failed.
Modified parameters have been restored for model N16-9122_SW0003.PRT.
Modified relations have been restored successfully.
Could not create model N16-9122_SW0003. Aborting.
--
Lyle Beidler MGS Inc 178 Muddy Creek Church Rd Denver PA 17517 717-336-7528 Fax 717-336-0514 <">mailto:-> - <">http://www.mgsincorporated.com> This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
