cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Sketched Hole Depth

unknown1
Newbie

Sketched Hole Depth

Fellow Users,

I'm trying to find out if there is a way to control the length (depth) of a sketched hole to match up with the thickness of the wall of a part in Wildfire 2 WITHOUT using relations. I am looking for something similar to "up to surface/reference".

I know I can just make the sketched hole length much longer than the wall thickness would ever be, but that may cause problems if there is another parallel wall beyond the hole.

I couldn't find any info at PTC.com or on this message board.

Any ideas or creative work-arounds?

TIA,

Mike
1 REPLY 1

Re: Sketched Hole Depth

Announcements