I have created slots in a sheetmetal part. I then added a centerline (axis point) to the center of the slots. When I get to the drawing phase, the formed view shows the center line correctly but the flat state shows the center line in correctly. (see attached pdf) How can I make the center lines show up correctly in the flat state?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
