We are working to address an issue with subscription email notifications. In the meantime, be sure to check your favorite boards for new topics.
Hi everyone,
I'm not very familiar with prt and asm quoting and I would like to ask you a question:
commonly in a DRW it is possible to create a snap line associated with a geometric element on which to fix a dimension, is it possible to do this also with the dimensions created in prt and asm models?
Thank you
P.S. I'm using Creo 9.0.8.0
Solved! Go to Solution.
Unfortunately, the answer is no - at least as of Creo 10.0. It would be a nice addition but so far, snap lines are only available in drawing mode.
Thanks!
-Brian
Unfortunately, the answer is no - at least as of Creo 10.0. It would be a nice addition but so far, snap lines are only available in drawing mode.
Thanks!
-Brian
Ok, thank you BrianMartin