The problem was that the cell had the following in it;
&desc
&DWG_DESC:D
That is what was causing the issue, can't have a single cell pointing to
two places I guess when using templates.
Coming from a format it is OK, but if you use the format on a template
drawing and then create new from template it does not work right.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.