Spellcheck for drawings in Creo parametric

[AP_10833295]

Spellcheck for drawings in Creo parametric,

Should have spellcheck suggestions for drawings.

[BenLoosli]

ModelCheck provides spellchecking for Creo drawings...and more.

[ThoRig]

I tried running modelcheck for a creo drawing, and received nothing.  After entering the drawing file number and selecting "Run", the background disappeared.  Are there some posted instructions somewhere to understand this process in more detail?

[BenLoosli]

Is this in your config.pro? modelcheck_enabled yes

Have you looked at the default_checks.mch file to be sure the proper checks you want are being executed?

[ThoRig]

1.  modelcheck_enabled is yes

2. default_checks.mch file is in the Common Files folder, and I do not have admin rights to it.  Even if I did, I do not know what you meant by "proper checks"

[Dale_Rosema]

Here are a couple of ideas on which to vote:

https://community.ptc.com/t5/Creo-Parametric-Ideas/Modelcheck-errors-spelling-lowercase-font-to-work-with-DIMENSION/idi-p/930551

https://community.ptc.com/t5/Creo-Parametric-Ideas/Add-spell-check-feature-using-MS-Office-dictionary-for-Creo/idi-p/462658

[ThoRig]

You can find info on the spell checker in the Help Center.  So far, I have not been able to get it to work, but according to below instructions, it's supposed to be easy.

[Chris3]

@BenLoosli has the right answer. You have to configure model check for spelling. Configuring model check can be a bear. The line you are looking for is this one:

NOTE_SPELL           YNEW       W       W       N       W       Y

It will be under <Model Check Root Install Folder>\config\check     in one of the mch files

[BenLoosli]

Have you run ModelCheck in Interactive mode with your drawing open?