Summary: Faceted Cylinders
‎Apr 30, 2014
04:56 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Apr 30, 2014
04:56 PM
Summary: Faceted Cylinders
It was the part accuracy. The part had accidentally been started with our mm start part and later the units were switched by keeping the same values rather than scaling.
Changed the accuracy to 0.0001" and that fixed it.
Thanks to Gary for the answer.
--
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Changed the accuracy to 0.0001" and that fixed it.
Thanks to Gary for the answer.
--
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
0 REPLIES 0