Community Tip - Learn all about PTC Community Badges. Engage with PTC and see how many you can earn! X
I have been looking but not finding an answer. I am trying to start a sheetmetal part with a revolve but I want to dimension to the ID in one section of the revolve, have a small offset and then dimension to the OD of the second section. In WF4 I can thicken while sketching and create these two dimensions. When in Creo 2.0 and while sketching my revolve section I can not select thicken (setup-feature tools-thicken) because it is grayed out. If I create a second (unattached) revolve section after my initial revolve I can thicken it because this feature is not grayed out. Why does Creo allow the use of thicken in a second revolve but not in the initial feature of a revolve sketch?
Solved! Go to Solution.
Eric,
This was an issue till Creo 2.0 M090 and corrected in M100. Check attached image
Eric,
This was an issue till Creo 2.0 M090 and corrected in M100. Check attached image
Thank you. I will work on upgrading.