cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - When posting, your subject should be specific and summarize your question. Here are some additional tips on asking a great question. X

Unable to flatten the cables using Auto Fan (Harness Manufacturing) Option

MB_10357724
11-Garnet
11-Garnet
‎Jul 05, 2022 02:43 PM
‎Jul 05, 2022 02:43 PM

Unable to flatten the cables using Auto Fan (Harness Manufacturing) Option

I am using Creo Parametric Release 3.0 and DatecodeM120

Unable to flatten the cables using Auto Fan (Harness Manufacturing) Option.

Here are the errors that I faced
Error Messages while using Auto Fan Option - Some wire/cable(s) were not fanned out due to insufficient length

Error Messages while using Manual Fan Option - Cables are already layed out to this location

Labels:
0 Kudos
Notify Moderator
1 REPLY 1
VladimirN
24-Ruby II
24-Ruby II
(To:MB_10357724)
‎Jul 06, 2022 02:17 AM
‎Jul 06, 2022 02:17 AM

 Hi,

 

Similar question before - "Problems in cabling (flatening, documentation)": https://community.ptc.com/t5/3D-Part-Assembly-Design/Problems-in-cabling-flatening-documentation/m-p... 

0 Kudos
Notify Moderator
Announcements
NEW Creo+ Topics: Real-time Collaboration


Contact Community Management
Top Tags