cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Unbend part

amitshah
1-Visitor
1-Visitor
‎May 30, 2016 05:24 AM
‎May 30, 2016 05:24 AM

Unbend part

I need to unbend sheetmetal component.

Attached is the image and part for reference


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
prt0001.prt.1.zip
0 Kudos
Notify Moderator
1 REPLY 1
manjunathrv
17-Peridot
17-Peridot
(To:amitshah)
‎May 31, 2016 05:23 AM
‎May 31, 2016 05:23 AM

Use the attached model as reference. You need to create 2 seperate features - Plannar wall and a flange. then the unbend and flat pattern will work.

prt0001.prt.1.zip
Notify Moderator
Announcements
NEW Creo+ Topics: Real-time Collaboration


Contact Community Management
Top Tags