Welding: Weld Wizard: Preparation and Solid weld

[Sergey]

Hello everyone.

I have an issue: Two pipes with straight edges (i.e. not prepared edges) are connected to each other. By using the Weld Wizard I create preparation with the following parameters: 2 mm root opening, 2.5 mm depth and bevel angle of 35°. Everything works well except that the weld being created as a surface. When I choose "Solid" in "Weld geometry type" Regeneration failure message pops up. How do I get Solid weld type?

I will appreciate some help in solving this issue. 

Best,

Sergey

[Sergey · Accepted solution]

I think that I found solution: Weld size should be equal to the pipe thickness in order to create a solid weld. 

In my opinion this is a very usefull information.

 

[Mahesh_Sharma]

@Sergey 

Thanks for sharing the details. 

You may accept your comments on post as solution.