Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X
This should be a simple question. We are in a transition to Creo 2.0 from WF4. I noticed that when we retrieved some drawings that were done in WF4, the hatching did not show in section views. Same too in 3D model. This obviously is affecting the CAD worker and publishing. So what did I miss?
Antonio Villanueva
Sr. Software Engineer
United Technologies Aerospace Systems
Knew it was simple. License setup was calling Pro_Mech_Foundation licenses first. Stupid! That license should taken out back and shot.
Antonio Villanueva
Sr. Software Engineer
United Technologies Aerospace Systems