Can anyone explain how Mechanica treats assemblies when the components
in the assembly have previous loads and constraints applied to them? I
have an assembly of two parts where one part was previously analyzed
individually so it has a full set of loads and constraints. I deleted
the constraints, but would like to KEEP the load definition as it's a
bit complicated. It shown in my assembly in Mechanica. WILL it be
applied when I run the analysis on the assembly?
thanks in advance...
Paul Korenkiewicz
FEV , Inc.
4554 Glenmeade
Auburn Hills, MI, 48326-1766
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.