assembly controlled with parameter and family table
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
assembly controlled with parameter and family table
I have a main assembly and within that assembly, there is a motor assembly. The motor assembly is an assembly with 5 different motors, controlled by a family table.
Is it possible in the main assembly, to control the family table with parameters?
I want to choose a motorassembly with an parameter or relation.
Right now i choose the right motor with ''replace selected component or UDF'', but i think it can be changed in a smarter way than that.
Hope you guys can help me out! 😄
Solved! Go to Solution.
- Labels:
-
Assembly Design
-
Flexible Modeling
-
General
- Tags:
- family table
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hello @BA_10140001
You may want to drive this with logic shown in below movie.
Regards,
Serge
- Chapters
- descriptions off, selected
- captions settings, opens captions settings dialog
- captions off, selected
This is a modal window.
Beginning of dialog window. Escape will cancel and close the window.
End of dialog window.
This is a modal window. This modal can be closed by pressing the Escape key or activating the close button.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hello @BA_10140001
You may want to drive this with logic shown in below movie.
Regards,
Serge
- Chapters
- descriptions off, selected
- captions settings, opens captions settings dialog
- captions off, selected
This is a modal window.
Beginning of dialog window. Escape will cancel and close the window.
End of dialog window.
This is a modal window. This modal can be closed by pressing the Escape key or activating the close button.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator