So I put a hole in, want to annotate it with the dowel symbol. I go to the model add symbol. The pro...
4 Replies 152 Views
I am using Creo Parametric 3.0 M170 Not able to retrieve the fasteners in the large assembly, the sy...
2 Replies 160 Views
Hi all, For extrude and revolve features that have sections defined as an external sketch, then one ...
I cant' figure out the correct equation to drive the wing outside diameter and wing inside diameter ...
by danders238 on 03-01-2021 09:40 AM
0 Replies 91 Views
Hi, Have top-level assembly where 2 square groove welds contained in sub assembly 2 levels down fail...
Is there any way to check if all the components in an assembly have a density assigned to them?
2 Replies 321 Views
I am using Creo Parametric 6.0 126.96.36.199 What is the exactly behavior of the config option: "system_wi...
8 Replies 382 Views
Is there a way to bulk modify certain parameters when sketching?For example, I have four parallel li...
This might be a simple question - sorry I am new to creo. I have imported a couple of iges files and...
Hi Guys, is there a way to change the order of windows in the drop-down menu to activate a Creo-wind...
In the layout if I create a template to have the three standard views, is there some way to make the...
by GK_8928886 on 02-25-2021 05:12 AM
0 Replies 94 Views
Hi all, Is there a way to pre-select the "Capped Ends" option when extruding a surface? I tried to l...
2 Replies 145 Views
Hi Guys, Lets say I have an assembly. In the assembly I have a core, and cavity. In the assembly I w...
Using Creo 4.0, I'm having issues with inserting a Datum Feature Symbol that has a gap from the edge...
Does anyone know if you can load the auto axis utility in Creo 3? If so, how do you do this? We had ...
Hi, I want to analyze a mechanism but I don't know how to implement it. The pictures shows the 3 par...
Hello everybody absolute beginner here so please bear with me. Creo 7. I'd like to use the show and ...
We've been using Creo 4.0 for a while, and I'm aware that "support" for that release has been over f...
2 Replies 237 Views
Newbie here, I apologize in advance if this is the wrong place to post this (apparently, I do not ha...
12 Replies 1623 Views
I'm trying to create a Spot Weld in CREO 2.0. I've created the Datum Point... but I can't select it ...
Hello, This is my first time using Pro/Program, and my intent is to change out a series of sub-assem...
Is there a way to add tables to a combination state? Tables that can hold information
Whenever I start a new part and sketch, my initial sketched lines start at lengths of 132000" for ex...
by erinhoover on 02-16-2021 05:26 PM
0 Replies 90 Views
Hello, Has anyone had the issue of the BOM balloon quantities changing when an assembly or drawing i...
8 Replies 1137 Views
Hi all, Currently, Creo ModelCHECK only supports checks for a few data types: Design Assemblies Soli...
4 Replies 208 Views
hello I need some steps for unbend a part model and create flattpattern for this. i try to reconstru...
5 Replies 336 Views
Does anyone use intent surface type of datum reference feature? During its creation, one has option ...
I have a part file and a drawing file. I have extensive dimensions on the drawing but need one with ...
Showing motion has been a challenge....Those that are familiar with solidworks probably know configu...
Good morning, I know that I can find the session id of a component in the Relations window. What I d...