It used to be pretty simple to convert an insert to a pin joint back in WF2.
I'm on WF4 and I don't see any obvious way to do this.
I'm trying to convert the shackle on a hoist ring to a mechanisim constraint so I can drag it in the top assy to create some views for a critical lift safety note.
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
