create sheetmetal "flat1" on Creo3

[Dom_CHENTRE]

Hi alls,

Since I'm using Creo3; I can't create flat state from a sheetmetal part.

On Creo2, it was very simple...

What I'm not understanding ???

Thanks

[tgriffin · Accepted solution]

Go to File>Options>Configuration Editor and set enable_flat_state to yes.  Then go to File>Prepare>Model Properties and click change next to flat state instances.  Then set up your flat state, which will create a family table for you with a flat and fully formed state.

[Dom_CHENTRE]

thanks a lot 😉