Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
When I try to put a driven diameter dimension in my detail drawing view, it comes in as a radius callout. Is there a wetting to change this? If not, How do I change the properties of the hole callout to recognize the diameter instead of the radius?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
