Hello proe users,
I have found a problem when mirroring a cut that was created at the assembly level.
-Feature "plug_1" was created at the assembly level over "1_cuerpo.prt", and the material is removed both at the part level and assembly level, see image plug_1_definition.
-Feature "plug_2" is also created at the assembly level, as a mirror of "plug_1" but the material to be removed is from "2_cuerpo.prt". The feature is created and is does remove material at the assembly level, but it does not intersect the part and when I open "2_cuerpo.prt" nothing has been removed. Please see attached image for definition of this feature.
From image plug_2_definition I can see that the models are being intersected at different levels, "1_cuerpo.prt" at the part level while "2_cuerpo.prt" is intersected at the assembly level only. I have played around with the intersection controls, but I haven´t been able to get "plug_2" to intersect "2_cuerpo.prt", thus making it visible at the assembly and part level.
Any ideas, thoughts are appreciated.
regards
AL.
If you can´t see the images in the exploder you can download them from the cad forum.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
