cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about the Community Ranking System, a fun gamification element of the PTC Community. X

"Insert here" bar missing

hwanho
7-Bedrock

"Insert here" bar missing

I am using Creo Parametric - Release 8.0 (connected) 8.0 8.0.0.0

Hello
I can't see the "Insert Here" bar in the Creo 8.0.0.0
I attached capture files. Could you check it?
Thanks
5 REPLIES 5
TomU
23-Emerald IV
(To:hwanho)

Not seeing any files attached.

 

This is from Creo 8.0.0.0:

TomU_0-1621976088020.png

 

Starting in Creo 7 the "Insert Here", or Insert Indicator, was switched to the green bar. It behaves identical to the Insert Indicator in that you can drag and drop it to enter Insert Mode. Then RMB > Exit Insert Mode to exit. 

-------
Matt Huybrecht


@hwanho wrote:
I am using Creo Parametric - Release 8.0 (connected) 8.0 8.0.0.0

Hello
I can't see the "Insert Here" bar in the Creo 8.0.0.0
I attached capture files. Could you check it?
Thanks

Hi,

see green horizontal line in picture uploaded by TomU. This is former "Insert Here" bar.


Martin Hanák
TomU
23-Emerald IV
(To:hwanho)

Not sure if this is your case or not, but this article just rolled out from PTC:

https://www.ptc.com/en/support/article/CS345672

 

TomU_0-1622052457220.png

 

Kristof_D
13-Aquamarine
(To:hwanho)

It's the same in Creo 7.

Go to the model tree settings and make sure "Features" is selected.

If you press apply, the bars should come back.

Kristof_D_0-1651745373723.png

 

I'll log another case to E-support and suggest this as a change.

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags