cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

"Outline aborted, sketch again" for detail views

moregan
1-Visitor

"Outline aborted, sketch again" for detail views

I'm trying to make some detail views for an assembly which I have.

I have not had trouble with creating detail views in the past.

However, today, every time I've sought to create a detail view, I select the center point without issue. Then, when I attempt to draw a spline to constrain the detail view, I repeatedly receive "Outline aborted, sketch again" as an error. I've tried dozens of times with different shaped splines, overlapping, not overlapping, and everytime it fails and gives me the same message.

Does anyone have an idea why this might be happening, how to resolve it, or how to work around it?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags