cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

routing pipe with slope

cadjunky
1-Newbie

routing pipe with slope

I am trying to route pipe using cartesian and would like to apply slope.
Presently, only one coordinate system is available to change (others are
grayed out) when extending a 'set start'. I would like to have the ability
to have x and y to include a slope in my pipeline. Any ideas?


Best Regards,
Steve Voelz
Piping Designer
Pure-Flo MPC, ITT Industries
9625 55th St
Kenosha, WI 53144
Phone #(262)-654-6466 x324
Fax #(262)652-7337

-

Running:
Wildfire 2 build M090
Dell Precision 360
2.8 Pentium 4
FX Quadro 500
1 GB Ram
Windows 2000 NT

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements