Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
All,
I recently updated our datecode to WF3 m200 x64from WF3 M120 x32. we noticed in our ncl file that we are getting a line that says "GOTO / 0,0,0,". In our ncl file prior to our datecode change this line was not showing, it would just show the first goto position. Is there a setting somewhere so this "home" position will not show up? Or is there somthing about the m200 datecode that is causing this difference?
Thanks
Brad