cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about PTC Community Badges. Engage with PTC and see how many you can earn! X

Translate the entire conversation x

Creo View: Multi-byte characters are not supported for NX PMI conversion

eliu
14-Alexandrite
14-Alexandrite
‎May 28, 2019 04:17 AM
‎May 28, 2019 04:17 AM

Creo View: Multi-byte characters are not supported for NX PMI conversion

Need an improvement in NX PMI conversion for the Multi-byte character in the future release of Creo View and Creo View adapter for NX.

Based on the comments in the chapter of Supporting NX with Model View States in 5.1 F000 Crreo View MCAD Adapters Installation and Configuration Guide

  • NX PMI conversion has the following limitations: No Multi-byte character support. Only ASCII characters in PMI annotations are converted.

 

Labels:
Notify Moderator
1 REPLY 1
VladimirN
24-Ruby III
24-Ruby III
(To:eliu)
‎Aug 20, 2019 03:21 AM
‎Aug 20, 2019 03:21 AM

You can bring your idea in "Creo Ideas" area, here: https://community.ptc.com/t5/Addtl-Creo-Ideas-Creo-View/idb-p/creogeneralideas

0 Kudos
Notify Moderator
Announcements



Contact Community Management
Top Tags